Aosept Plus Avec Hydraglyde 1x 90ml + 1 Lenscase

Lens wearers who :have sensitive eyes prefer a system peroxide are experiencing a sensation of dryness and irritation related to the combination of lens and maintenance solution

1. Wash your hands and dry with a clean towel.2. Open the basket marked \" L \" and place your left lens on the curved part. Close the basket, taking care not to pinch the lens.
2. Repeat the same procedure with your right lens on the curved part of the other basket marked \" R \".
3. Open the top of the cap of the bottle AOSEPT PLUS, and then fold it back and away.
4. Rinse lenses placed in baskets with AOSEPT PLUS for 5 seconds.
5. Fill the pouch with the solution AOSEPT PLUS to the line-marker. NEITHER ABOVE NOR BELOW.
6. Place the basket in the case AOSEPT PLUS and close it. Do not shake the case.
7. Keep the holster in the vertical position.

- If bubbles escape through the hole in the lid, it may be that it remains the solution AOSEPT PLUS non-offset. Empty the solution from the case of soaking and clean the solution that would have spilled on the surface on which was placed the case of soaking AOSEPT MORE. Rinse the case AOSEPT PLUS and the basket holder lenses AOSEPT PLUS with a sterile saline solution. If the solution overflows, wipe immediately with a paper towel. Wash your hands thoroughly before handling your lenses or touching your eyes. REPEAT The OPERATION OF DECONTAMINATION ABOVE. 9. Let the lenses soak for 6 hours minimum or overnight to neutralise solution. 10. Remove your lenses from the basket holder lenses. 11. Your lenses are now ready to be worn. 12. Discard the used solution, rinse the case AOSEPT PLUS and the basket holder to lenses with a sterile saline solution. DO NOT USE TAP WATER OR WATER NON-STERILE. 13. Let the air dry by inverting the gate-lenses out of the holster. 14. If you do not intend to wear your lenses immediately after the decontamination/neutralization, you may store up to 14 days in the solution AOSEPT PLUS offset in the case has not been opened. Beyond this time, your lenses must be cleaned and decontaminated again with AOSEPT MORE before being worn. According to the recommendations of your ophthalmologist, you can rinse your lenses prior to installation with a saline solution.

Hydrogen peroxide 3%, phosphoric acid, sodium chloride, phosphate buffer, poloxamer, HydraGlyde® Moisture Matrix (polyoxyethylène-polyoxybutylène)